BC300.
Two views.
One clear display.
Connection, camera placement and display controls for the BC300 dual-camera monitoring system.
Download manual ↗Choose your view
LEFT
Show camera 1.
RIGHT
Show camera 2.
M
Return to the dual-channel screen.
Connect before you power on.
Switch power off
Turn the system off before installing cameras or extension cables. Align each connector before inserting it; do not force the pins.
Connect both cameras
Follow the two camera connections in the manual. Secure cables so they do not interfere with seats, seat belts or vehicle controls.
Use the supplied power cable
The guide supports the lighter adapter with its ON/OFF switch, or USB power. When using USB, use the original supplied cable. The monitor is rated 5V / 1A.
Secure the cameras, then adjust.
Head-restraint mounting
Fit each camera using the supplied base and straps. Tighten the horizontal strap, then the vertical strap, and rotate the camera to frame the view.
Check the monitor position
Secure the suction mount and keep the screen clear of the driver’s road view, airbag areas and controls. Check the image while parked.
Test both channels
The system starts in dual-screen view. Use LEFT and RIGHT to inspect each camera individually, then M to restore both views.
Start with power and connections.
No display
Check the adapter switch and power connection. If using USB, try the original cable and an appropriate supply. Reconnect only with the system powered off.
One camera has no image
Switch to that channel and inspect its camera and extension-cable connections. Check connector alignment and cable damage before powering on again.
View is misplaced
Adjust the camera angle and retighten its straps. This page covers a monitor system; the guide does not provide memory-card recording or dash-cam app instructions.
Resources for your BC300.
BC300 user manual
Connection diagram, mounting steps and display controls · revision May 2025.
Warranty information
Warranty and return information →
Still need a hand?
Send Support your model label, firmware version and a clear description of the issue.